-
Created On: 04/18/2019
in Sit-Stand Solutions
It can hold up to 200lbs including the weight of the table top.
-
Created On: 04/18/2019
in Sit-Stand Solutions
The height adjusts at 1.4" per second. There will not be any noticeable difference in speed with additional weight applied.
-
Created On: 04/18/2019
in Sit-Stand Solutions
Please submit your inquiry by clicking on the Ask a Question button above or call Fellowes Customer Service and we will be glad to assist you: 1.800.955.0959 or 1.800.945.4545, M-F, 7am-7pm CST.
-
Created On: 04/18/2019
in Sit-Stand Solutions
The three stage legs provide height adjustment from 24.2” to 48.5”.
-
Created On: 04/18/2019
in Sit-Stand Solutions
Make sure your table top is face down on a soft, clean surface and place base on table. Use the 5mm Allen key to loosen the (8) set screws on the inward side of the cross channels. Expand or contract accordingly until the ends are flush with the tab...
-
Created On: 04/18/2019
in Sit-Stand Solutions
This will depend on your setup. If any of your cables are routing to the floor be sure that they can accommodate the full range of motion up to 48.5”. Refer to Accessory Installation Step 1 in the instruction manual: ...
-
Created On: 04/18/2019
in Sit-Stand Solutions
If the table feels unbalanced adjust the (4) levelling pads located on the bottom of the feet. Turn clockwise to lower and counter clockwise to raise. ...
-
Created On: 04/18/2019
in Miscellaneous
The majority of Fellowes branded products are sold through our commercial, retail, and online partners. The assortment available for direct purchase on fellowes.com changes frequently for a variety of reasons. If there is a specific product you are ...
-
Created On: 04/18/2019
in Sit-Stand Solutions
The Levado Adjustable Height Desk Base accommodates table tops 48"-72" wide x 24"-30" deep.
-
Created On: 04/18/2019
in Sit-Stand Solutions
There are two groups of memory settings, each with two height settings. To toggle between the two users, momentarily press the M button and display will read U1 or U2. Up to four memory stop positions can be used to save specific heights of the work...